audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Steering column switch module and electronic ignition lock > < Removing and installing turn signal switchE2, cruise control system switchE45, intermittent wiper switchE22

A1

Removing and installing steering lock housing
Removing and installing steering lock housing
Special tools and workshop equipment required
t  Socket -T10424-
   
Removing
–  Remove steering column switch module → Chapter.
–  Unplug electrical connectors -1, 4-.
–  Remove shear bolt -2- using socket -T10424-.
–  Detach steering lock housing -3-.
  Note
If it is not possible to remove the shear bolt with the socket -T10424-, the bolt will need to be drilled out using an angle drill and a Ø 8.5 mm bit.
Remove ignition/starter switch and lock cylinder before renewing steering lock housing.
t  Removing ignition switch → Chapter
t  Removing lock cylinder → Chapter
  A94-11101
Installing
Installation is carried out in the reverse order; note the following:
–  Tighten new bolts -arrows- until head shears off.
–  Install steering column switch module → Chapter.
  A94-11113

Steering column switch module and electronic ignition lock > < Removing and installing turn signal switchE2, cruise control system switchE45, intermittent wiper switchE22