audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Windscreen washer system > < Adjusting wiper arms

A1

Removing and installing windscreen wiper motorV
Removing and installing windscreen wiper motor -V-
   
Removing
–  Remove wiper arms → Chapter.
–  Detach seal -2-.
  Caution
Risk of damage to cowl panel trim.
Apply a small quantity of soap solution to transition between windscreen and cowl panel trim.
–  Starting at edge of windscreen, carefully pull cowl panel trim -1- vertically up and out of retainer at windscreen -arrows-.
  A50-10151
–  Remove plenum chamber partition panel → Rep. gr.50.
–  Remove bolts -1, 3, 5-.
–  Unplug electrical connector -2-.
–  Disengage wiper frame -4- with linkage and wiper motor to one side -arrow A- and take out towards engine compartment -arrow B-.
Installing
l  Tightening torque → Fig.
Installation is carried out in the reverse order; note the following:
–  Fit wiper motor with wiper frame in vehicle.
–  Tighten bolts → Fig..
–  Install plenum chamber partition panel → Rep. gr.50.
–  Adjust wiper arms → Chapter.
  A92-10176

Windscreen washer system > < Adjusting wiper arms