audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing securing bar for fuse holder BSB > < Removing and installing bracket for fuse holder BSB

A1

Removing and installing fuse holder BSB
Removing and installing fuse holder B -SB-
   
Removing
–  Disconnect earth cable from battery with ignition switched off → Chapter.
–  Release retaining tabs -2, 4--arrow- using screwdriver -3- and detach cover -1-.
  A97-11272
–  Mark assignment of electrical wiring -4 ... 9- at screw connections for re-installation.
–  Unscrew nuts and pull electrical wiring out of clamps.
–  Remove nut -2-.
–  Release retaining tabs -arrows- with a small screwdriver and detach bracket -3- together with fuse holder B from battery clamp of positive cable.
–  If fitted, remove fuse holder -1- → Chapter.
Installing
l  Tightening torque → Fig.
Installation is carried out in the reverse order; note the following:
–  Install fuse holder → Chapter.
–  Connect battery. Steps required → Anchor.
  A97-11273

Removing and installing securing bar for fuse holder BSB > < Removing and installing bracket for fuse holder BSB