audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Relay carriers, fuse carriers (vehicle interior) > < Unplugging door separating connector

A1

Removing and installing fuse holder ASA in luggage compartment
Removing and installing fuse holder A -SA- in luggage compartment
   
Removing
–  Disconnect earth cable from battery with ignition switched off → Chapter.
–  Lift luggage compartment floor and hook onto body.
–  Take out vehicle tool kit.
–  Remove bolts -arrows- and detach retainer -1-.
  A27-10248
–  Slacken off nut -1- several turns and disconnect battery clamp of positive cable together with fuse holder A from battery terminal.
–  Release retaining spring -3- and open cover -2- over fuse holder A -arrow-.
  A97-10316
–  Unbolt electrical wiring -1, 5, 6, 8-.
  Note
Disregard -items 2, 3-.
–  Disconnect battery clamp -4- of positive cable together with fuse holder A from battery terminal.
–  Remove battery isolation igniter -N253--item 7- → Rep. gr.69.
–  Remove fuse holder A.
  Note
Exact assignment of contacts in fuse holder A can be found in applicable current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installing
l  Tightening torque → Fig.
Installation is carried out in the reverse order; note the following:
–  Install battery isolation igniter -N253- → Rep. gr.69.
  A97-10453

Relay carriers, fuse carriers (vehicle interior) > < Unplugging door separating connector