A2
| Renewing protective side strips (top) |
Note| t | It is not possible to remove the protective side strips without destroying them. |
| t | To facilitate removal, heat protective side strips using a hot-air blower. |
| t | The surfaces to be bonded must be at least as warm as room temperature. If necessary, heat up with a hot-air blower. |
| 1 - | Protective side strip (front) |
| q | Bonding surface must be free of adhesive residue, dust and grease. |
| q | First clean outer panel using a cleaning solvent. |
| q | Apply silicon remover to the bonding area and rub it dry. |
| q | Remove protective foil -arrow-. |
| q | Fit protective side strip with guide pins onto door as shown. |
| q | Press protective side strip on firmly all along. |
| 2 - | Protective side strip (rear) |
| q | Installation as described for protective side strip (front). |
