A2
With solid backrest cover panel |
WARNING
|
1 - | Backrest cover |
t | Removing |
– | Remove seat → Chapter. |
– | Remove backrest → Chapter. |
– | Remove side airbag module → Chapter. |
– | Prise cover fastening strip out of backrest cover panel -7-. |
– | Unfasten backrest cover panel -7- from clip -6-. |
– | Pull out backrest cover panel -7-. |
– | Disengage backrest cover at bottom rear. |
– | Remove head restraint -8- by pressing button at left rod. |
– | Remove head restraint guide -9- → Fig. |
– | Lift cover and pinch off -A- staples -5-. |
– | Detach padding -2-. |
t | Installing |
– | Cut out cover on vehicles with side airbag → Chapter. |
– | Align cut-out in piping with slot in backrest cover panel → Fig. |
– | Use upholstery stapler -V.A.G 1634- to fit new staples. |
– | To facilitate installation, push back longitudinal rods as far as first transverse rod. |
– | When fitting, staple transverse rods first and then longitudinal rods. |
2 - | Padding |
3 - | Backrest heater |
q | Backrest heater and cover form one replacement part. |
q | Cover must be replaced as well on vehicles with backrest heater. |
q | Cut off cable -4- on vehicles with no backrest heater. |
4 - | Backrest heater cable |
5 - | Staples |
6 - | Clip |
7 - | Backrest cover panel |
8 - | Head restraint |
q | Head restraint cannot be dismantled; cover and padding form one replacement part. |
Rear outer head restraints are not identical to front head restraints. All head restraints are to be marked with adhesive tape on removal. |
9 - | Head restraint guide |