A2
Air duct in heater/ in air conditioner |
A - | Fresh air intake |
q | Via fresh-air intake ducts in the engine compartment and the passenger compartment and via an air duct installed under the bonnet → Chapter and → Chapter |
B - | Interior air intake (recirculated air mode) |
q | Via the passenger's footwell |
C - | Fresh-air blower -V2- |
D - | Dust and pollen filter |
E - | Evaporator |
q | Only in vehicles with an air conditioner |
F - | Heat exchanger |
G - | Heating element for additional heater -Z35- |
q | Only provided for vehicles with diesel engine, installation depends on equipment level → Chapter. |
q | Different versions → Chapter. |
q | Depending on the equipment level, vehicles built up to 2002 may have an electric additional heater or a fuel-powered additional heater → Chapter, → Chapter, → Relevant Workshop Manual Diesel Direct Injection and Glow Plug System; Repair group 01 and → Additional Heater; Repair group 82 |
H - | To the windscreen vents |
J - | To the dash panel vents |
K - | To the driver's side footwell vent |
L - | To the rear footwell vents |
M - | To the driver's side footwell vent |
1 - | Fresh-air flap |
q | Shown in the “closed” position |
2 - | Recirculated air flap |
q | Shown in the “open” position |
3 - | Temperature flap “1” |
q | Shown in the “heating” position |
4 - | Central flap |
q | Shown in the “open” position |
q | The shape of the two outer flaps allows air to flow to the vents when the centre flap is closed. |
5 - | Defrost flap |
q | Shown in the “closed” position |
6 - | Footwell flap |
q | Shown in the “closed” position |