A2
| Silencers - exploded view |
| 1 - | Nut |
| q | Renew |
| q | 25 Nm |
| 2 - | Starter catalytic converter |
| q | Protect against knocks and impact |
| q | Removing and installing → Chapter |
| 3 - | Gasket |
| q | Renew |
| 4 - | Rubber mounting |
| q | Renew if damaged |
| 5 - | Centre silencer |
| q | Combined in one unit with main catalytic converter as original equipment. Can be renewed individually for repair purposes |
| q | Cutting point → Chapter |
| 6 - | Clamp (rear) |
| q | Installation position → Fig. |
| q | Tighten bolt connections evenly |
| 7 - | Nut |
| q | 23 Nm |
| 8 - | Bolt |
| q | 23 Nm |
| 9 - | Mounting |
| q | Renew if damaged |
| 10 - | Rubber mounting |
| q | Renew if damaged |
| 11 - | Rear silencer |
| 12 - | Rubber mounting |
| q | Renew if damaged |
| 13 - | Bracket |
| q | 23 Nm |
| 14 - | Nut |
| q | M8: 23 Nm |
| q | M10: 40 Nm |
| 15 - | Nut |
| q | With bolt |
| q | 23 Nm |
| 16 - | Nut |
| q | M8: 23 Nm |
| q | M10: 40 Nm |
| 17 - | Clamp (front) |
| q | For separate replacement of main catalytic converter and centre silencer |
| q | Installation position → Fig. |
| q | Tighten bolt connections evenly |
| 18 - | Main catalytic converter |
| q | Protect against knocks and impact |
| q | Combined in one unit with centre silencer as original equipment. Can be renewed individually for repair purposes |
| q | Cutting point → Chapter |
| 19 - | Gasket |
| q | Renew |
| 20 - | Front exhaust pipe |
| q | With flexible joint; do not bend flexible joint more than 10° – otherwise it can be damaged |
| q | Removing and installing → Chapter |
| 21 - | Rubber mounting |
| q | Renew if damaged |
|
|
|
|
