audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing ignition lock housing

A2

Removing
Removing
–  Remove airbag module → General body repairs, interior; Rep. Gr.69.
–  Remove airbag steering wheel → Chapter
–  Remove top and bottom parts of steering column switch trim → Chapter.
   
–  To prevent unintentional turning, secure coil connector -2- using adhesive tape -1-.
3 - Steering angle sender -G85-
–  Remove trim cover → Chapter.
–  Remove steering column switch with steering angle sender -G85-.
–  Detach cable retainer from steering column → Chapter.
–  Detach connector for immobiliser reader coil and ignition/starter switch → Chapter.
–  Unscrew earth connection from ignition lock housing → Chapter.
  A48-0331
–  Drill out or, if necessary, chisel out shear bolts -arrows- and remove ignition lock housing.
–  Remove lock cylinder → Electrical system; Rep. Gr.94.
–  Remove ignition/starter switch → Electrical system; Rep. Gr.94.
  A48-0343

Installing > < Removing and installing ignition lock housing