Electrical check on electrohydraulic steering
Test requirements
-
◆ Applicable current flow diagram
=> Current Flow Diagrams, Electrical Fault-finding and Fitting Locations binder
-
◆ Information on eliminating current defects
=> Technical Service Handbook
-
● Switch off ignition and electr. loads (headlights, lighting, fan ...) before starting check
-
● Remove front bumper
=> General Body Repairs, Exterior; Repair Group 63
-
● Fuses Si38 and Si C must be OK (for checking, take fuses out of fuse box)
-
◆ The entire electrical check is to be performed on vehicles for which the self-diagnosis does not give any indication of the source of the trouble.
-
◆ Merely the test steps recommended in the fault table (specific testing) are to be performed on vehicles for which the self-diagnosis provides a direct indication of the source of the trouble.
All the test steps in the Electrical Check are listed on Page 01-186.
|