audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
End of output > < Fault table

A2

Erasing fault memory
Erasing fault memory
If fault memory cannot be erased, interrogate it again and eliminate fault.
After erasing fault memory, faults are not updated until ignition has been switched off and on again.
Requirements:
l  Fault memory interrogated → Chapter
l  All faults rectified
On completion of fault memory interrogation:
   
Indicated on display:
–  Press keys 0 and 5 (“Erasing fault memory”).
  
Rapid data transfer                HELP
Select function XX
Indicated on display:
–  Confirm entry by pressing Q key.
  
Rapid data transfer                    Q
05 - Erasing fault memory
Indicated on display:
Fault memory has now been erased.
–  Press → key.
  
Rapid data transfer                   ->
Fault memory erased
Indicated on display:
If however the following message appears:
  
Rapid data transfer                HELP
Select function XX
Indicated on display:
Test procedure not OK
Adhere exactly to test sequence: First interrogate fault memory, eliminate any faults and then erase memory.
  
Attention:                              ->
Fault memory not interrogated

End of output > < Fault table