A3 L4-2.0L Turbo (BPY) (2006)
Trim Panel: Service and Repair
Lower C-pillar Trim, Removing And Installing
Lower C-pillar Trim, Removing And Installing
Removing
-
Remove rear seat bench.
-
Remove 1/3 rear seat backrest.
-
Remove 2/3 rear seat backrest
-
Unclip rear sill panel strip - 2 - in joint area to lower C-pillar trim - 1 - in - direction of arrow -.
-
Unclip cover plug - 3 - from trim.
-
Remove bolt - 2 -.
-
Carefully remove lower C-pillar trim - 1 - from upper C-pillar trim - 4 - from body and retaining clip - 6 - from threaded pin - arrows -.
-
Remove lower C-pillar trim.
Installing
Installation is reverse of removal, but note the following:
NOTE:
-
Replace damaged spring clamps.
-
Pull door seal rubber lip - 5 - over lower C-pillar trim edge.
-
Install 2/3 rear seat backrest.
-
Install 1/3 rear seat backrest.
-
Install rear seat bench.
Tightening torque
Component
Nm
Lower C-pillar trim to body
2.5