A3 L4-2.0L Turbo (BPY) (2006)
If the specified value was not obtained:
-
Replace the Camshaft Adjustment Valve 1 N205.
If the specified value was obtained:
Checking voltage
-
Switch the ignition on.
-
Using a Multimeter , Check the Camshaft Adjustment Valve 1 N205 electrical harness connector terminal to the Motronic Engine Control Module
(ECM) Power Supply Relay J271 terminal 2/86 for voltage.
-
Switch the ignition off.
Specified value: battery voltage.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) J220.
-
Using a Multimeter , Check the Camshaft Adjustment Valve 1 N205 electrical harness connector terminal 2 to the Motronic Engine Control
Module (ECM) electrical harness connector T60 terminal 20 for an open circuit.
Camshaft Adjustment Valve 1
Motronic Engine Control Module
N205 electrical harness
(ECM) electrical harness connector
connector terminal
T60 terminal or test box socket
2
20
Specified value: 1.5 Ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) J220.
-
Install the engine cover with air filter.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Mode 04: Reset/Delete Diagnostic Data
3. If the DTC memory was erased, generate readiness code.