A3 L4-2.0L Turbo (BPY) (2006)
-
Remove screws -3- for headlamp beam adjustment motor.
-
Turn HID bulb igniter -2- counter-clockwise -arrow- and remove from housing.
NOTE:
-
When igniter is turned, the electrical connection -1- is automatically pushed out of the connector housing.
-
On the left headlamp, the igniter can only be removed after removing the headlamp beam adjusting motor.
-
Turn HID bulb retaining ring counter-clockwise -arrow-.
-
Remove HID bulb from housing.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
-
Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that
evaporates on the bulb during operation can cause the glass to cloud over.
-
When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.
-
Insert new HID headlamp bulb in housing.
NOTE: Heed installation position: lug at top of bulb holder must engage in recess of HID headlamp bulb.
-
Secure HID headlamp bulb with retaining clip.
-
Install igniter
NOTE: Igniter must be installed before reconnecting electrical connection.