A3 L4-2.0L Turbo (BPY) (2006)
/Page-1512001.png)
Fluid - A/T: Service and Repair
Transmission Fluid Level, Checking
Transmission fluid level, checking 02E, 6 Speed Direct Shift FWD A/T
CAUTION:
^
Engine is not to be started if there is little or no oil in the transmission following repair work or severe loss of transmission fluid.
^
In this case, perform a preliminary filling of transmission fluid for direct-shift transmission.
^
Only the replacement part that is indicated as the exclusive transmission fluid for the direct-shift transmission 02E may be used. Other
oils can cause malfunctions or transmission failure.
Test conditions
^
Transmission not in emergency operating mode.
^
Vehicle on a flat surface.
^
Selector lever in "P", let engine run at idle.
^
Air conditioning and heater switched off.
^
Vehicle Diagnostic, Testing and Information System VAS 5051 A connected, Vehicle Self-Diagnosis and vehicle system "02 Transmission
electronics" selected.
^
At start of test, transmission fluid temperature must not be higher than 30°C; allow transmission to cool down if necessary.
Note:
^
The transmission fluid temperature will be read out on the vehicle diagnostic, test and information system VAS 5051 A.
^
The transmission fluid level varies with transmission fluid temperature.
^
Checking transmission fluid level when transmission fluid temperature is too low will result in overfilling.
^
Checking transmission fluid level when transmission fluid temperature is too high will result in underfilling.
^
Over and underfilling lead to impaired functioning of transmission.
Reading transmission fluid temperature:
Display on VAS 5051 A :
-
From list - 1 - select diagnostic function "08 - Reading measured value block".
