A3 L4-2.0L Turbo (BPY) (2006)
/Page-4108002.png)
-
Open pliers again and remove the stripped wire end.
-
Repeat this procedure on the other repair wire end.
-
For the repair of a 0.25 sq.mm wire, use a small yellow crimp connector from the Wiring Harness Repair Set VAS 1978A.
-
To press the crimp connector, use the Crimping Pliers (Base Tool) VAS 1978/1-2 from the Wiring Harness Repair Set VAS 1978A with the
Exchangeable Head, 0.35 mm-2.5 mm VAS 1978/1-1.
-
Slide the small yellow crimp connector onto the vehicle-specific single wire at one side and onto the repair wire at the other side.
-
Crimp the crimp connection at both wire ends using crimp pliers.
-
Repeat this procedure at the other repair wire end.
NOTE: Do not crimp wire insulation.
After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.
-
Put Shrink Tip For Hot Air Gun VAS 1978/15 on to Hot Air Gun, 220 V/ 50 Hz VAS 1978/14.
CAUTION:
Risk of damaging surrounding components.
-
When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot
nozzle of the hot air gun.
-
Always observe operating instructions of heat gun.
