A3 L4-2.0L Turbo (BPY) (2006)
-
Using a Multimeter, check the Leak Detection Pump (LDP) -V144- electrical harness connector terminal 3 for voltage.
Leak Detection Pump (LDP)
Measure to
-V144- electrical harness
connector terminal
- 3 -
Engine Ground (GND)
-
Operate the starter briefly.
Specified value: battery voltage.
-
Switch the ignition off.
If the specified value was not obtained:
-
Using a Multimeter , check the Leak Detection Pump (LDP) -V144- electrical harness connector terminal 3 to the Engine Component Power
Supply Relay J757 terminal 2/87 for an open circuit.
Specified value: Wire resistance max 1.5 Ohms.
If the specification is not obtained:
-
Check the wiring for a short circuit to Battery positive (+) or an open circuit.
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) J220.
-
Using a Multimeter, check the Leak Detection Pump (LDP) -V144- electrical connector terminal 1 to Motronic Engine Control Module (ECM)
J220 electrical connector T94 terminal 40 for an open circuit.