A3 L4-2.0L Turbo (BPY) (2006)
/Page-2695002.png)
When doing this, do not use any lubricants.
‹› By pushing the Teflon seal onto the fuel injector, the Teflon seal is expanded. For this reason, the Teflon seal must be contracted again, once it has
been pushed on. This is done in two steps. The procedure for this is as follows.
The 1st step of calibrating (adapting) the Teflon seal is performed using the calibration sleeve (T10133/7).
-
Using a rotating motion (approximately 180 ) and light pressure, push the calibration sleeve (T10133/7) over fuel injector up to the stop. Pull the
calibration sleeve (T10133/7 ) off again, rotating it in the opposite direction.
The 2nd step of calibrating (adapting) the Teflon seal is performed using the calibration sleeve (T10133/8).
-
Using a rotating motion (approximately 180) and light pressure, push calibration sleeve (T10133/8) over the fuel injector up to the stop. Pull
calibration sleeve (T10133/8 ) off again, rotating it in the opposite direction.
