A3 L4-2.0L Turbo (BPY) (2006)
/Page-2721002.png)
4. Slice insulator Part No. 06A 141 730 A lengthwise on one side to enable installation onto fuel line.
Figure 3
5. Install insulator as shown in Figure 3.
6. Apply tape or small tie-rap around insulator on line. Do not apply tape or tie-rap tightly. The insulator must be able to slide on fuel line. A
soap/water mixture may be applied to the line to ease insulator installation.
7. Move insulator into frame channel so that it is positioned halfway between rear of channel and oval access hole, as illustrated in Figure 2.
Figure 4
8. Install insulator around the black fuel line through the oval access hole in the frame channel as shown in Figure 4.
9. Move the insulator forward into frame channel and position where indicated in Figure 2. Move insulator carefully so that it does not slide off of
fuel line inside frame channel.
Figure 5
10. Install the foam insulator at the rear of the frame channel as shown in Figure 5.
11. Install right side underbody cover. Tighten fasteners to 2 Nm (20 in.-lbs.).
12. Road test vehicle and verify noise is eliminated.
Warranty
When procedure applies to vehicles under warranty, use the following:
