A3 L4-2.0L Turbo (BPY) (2006)
-
Push release tool T10238 into intended openings - arrow - up to stop, as shown, and remove accelerator pedal module.
Installing
-
Tightening torque.
Installation is in reverse order of removal, note the following:
-
Connect wiring router - 1 - and electrical connector - 2 - to accelerator pedal module - 5 -.
-
The connector must engage audibly.
-
Push accelerator pedal module onto securing studs - 6 -
-
Insert centering pin - 7 - into hole on vehicle floor.
-
Secure accelerator pedal module with bolt - 3 - and install cover cap - 4 -.