A3 L4-2.0L Turbo (BPY) (2006)
Headlamp Alignment Control Module: Service and Repair
Headlamp Range Control Module J431, Removing And Installing
Location: Below instrument panel, left.
Removing
NOTE: Should the Headlamp Range Control Module J431 require replacement, follow applicable component "Replacement" procedure using VAS
5051/5051 in operating mode "Guided Fault Finding".
-
Remove drivers storage compartment.
-
Disconnect electrical connection -2-.
-
Remove screws -3- and -4- and remove module -1- from instrument panel carrier.
Installing
Install in reverse order of removal, noting the following:
-
Install drivers storage compartment.
Tightening torque
Headlamp Range Control Module J431 to carrier - screw: 2 Nm