A3 L4-2.0L Turbo (BPY) (2006)
/Page-5185001.png)
Repairs and Inspections Required After a Collision: Service and Repair
Pyrotechnic and Restraint System Components, Removing and Installing after an Accident
Pyrotechnic and Restraint System Components, Removing and Installing after an Accident
Special tools, testers and auxiliary items required
‹› Use a suitable vehicle tester such as the vehicle diagnosis, testing and information system (VAS 5051B).
‹› The airbag control module can be used for up to 2 side airbag and/or belt tensioner deployments with airbag generation 8.*, except 8.R.
‹› The airbag control module can be used for up to two side, driver and passenger airbag and/or belt tensioner deployments with airbag generation
9.*, 10.* and 8.R.
‹› After the third deployment, the malfunction display "Control module defect" appears.
Airbag control module must be replaced:
‹› with driver and passenger airbag deployment "but not with airbag generation 9.*, 10.* and 8.R"
‹› after three side airbag, driver airbag, passenger airbag or belt tensioner deployments
‹› if housing is damaged
‹› if there is deformation on tunnel in 200 mm circumference around control module
Always replace the following:
‹› all deployed airbag units
‹› the battery interrupt igniter (N253)
Also with passenger airbag deployment:
‹› Instrument Panel
‹› deformed passenger module supports (cannot be reformed)
‹› all sensors for front airbag on front end
‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region
Also with driver airbag deployment:
‹› Coil connector with slip ring
‹› all sensors for front airbag on front end
‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region
Also with side airbag deployment:
‹› Pressure sensors on deployed side
‹› Cross acceleration sensors on deployed side
‹› Cover
‹› Upholstery
‹› Remaining cross acceleration sensors if anchorage point is deformed in sensor region
In addition:
‹› all belt retractors with deployed belt tensioners
