A3 L4-2.0L Turbo (BPY) (2006)
Camshaft Position Sensor: Testing and Inspection
Camshaft Position (CMP) Sensor G40, Checking
NOTE: Use only gold-plated terminals when servicing terminals in harness connector of Camshaft Position (CMP) Sensor G40.
Special tools, testers and auxiliary items required
-
Multimeter.
-
Wiring diagram.
Test requirements
-
The Motronic Engine Control Module (ECM) J220 fuses OK.
-
Battery voltage at least 12.5 volts.
-
All electrical consumers such as, lights and rear window defroster, switched off.
-
Vehicles with automatic transmission, shift selector lever into position "P" or "N".
-
A/C switched off.
-
Ground (GND) connections between engine/transmission/chassis OK.
-
Ignition switched off.
Procedure
-
Remove the engine cover with air filter.
-
Disconnect the Camshaft Position (CMP) Sensor G40 electrical harness connector - 1 -.
-
Switch the ignition on.
-
Using a Multimeter , Check the Camshaft Position (CMP) Sensor G40 electrical harness connector terminals 1 to 3 for voltage.