A3 L4-2.0L Turbo (BPY) (2006)
/Page-1244006.png)
Steering rack moves up to stop when this is done.
-
Apply LOCTITE (5910) to the plug threads.
-
Fill the plug with grease (G 052 192 A1), install it and tighten it.
-
Position the steering so it is in the straight position.
-
Coat the gasket - arrow - in the cover with grease (G 052 168 A1). Only apply a thin film of it.
-
Install cover with new seal.
Further installation is in the reverse order of removal.
-
Install and adjust thrust piece on steering pinion side. Refer to => [ Thrust Piece, Steering Pinion Side ] See: Steering and
Suspension/Steering/Steering Gear/Service and Repair/Removal and Replacement/Thrust Piece, Steering Pinion Side.
-
Install steering gear. Refer to => [ Electromechanical Steering Gear ] See: Steering and Suspension/Steering/Steering Gear/Service and
Repair/Removal and Replacement/Electromechanical Steering Gear.
-
Perform the adaptation and basic setting for the steering angle sensor.
Tightening Specifications, refer to => [ Electromechanical Steering Gear Assembly Overview, Generation I ] See: Steering and
Suspension/Steering/Steering Gear/Service and Repair/Removal and Replacement/Electromechanical Steering Gear Assembly Overview, Generation I
.
-
Perform vehicle alignment. Refer to => [ Measurement Procedure ] See: Maintenance/Alignment/Service and Repair/Measurement Procedure.
