A3 L4-2.0L Turbo (BPY) (2006)
/Page-4649003.png)
‹› Removing and Installing, refer to => [ Ball Joint ] See: Ball Joint/Service and Repair
‹› Replace if the transverse is damaged
16 - Nut
‹› 60 Nm
‹› Always replace after removal
17 - Nut
‹› 9 Nm
18 - Bolt
‹› 70 Nm plus an additional 90° turn
‹› Always replace after removal
‹› Different versions depending on market.
19 - Threaded Connection on Steering Gear
‹› 50 Nm plus an additional 90° turn
‹› Always replace after removal
20 - Threaded Connection on Stabilizer Bar
‹› 20 Nm plus an additional 90° turn
‹› Always replace after removal
21 - Bolt
‹› 70 Nm plus an additional 90° turn
‹› Always replace after removal
22 - Retainer Plate
‹› Cabriolet only
23 - Bolt
‹› 100 Nm plus an additional 90° turn
‹› Only tighten if pendulum support is bolted to transmission
‹› Always replace after removal
24 - Lower Bonded Rubber Bushing for Pendulum Support
‹› Removing and Installing, refer to => [ Bonded Rubber Bushing ] See: Front Subframe Mount/Service and Repair/Front Suspension.
25 - Bolt
‹› Tightening Specifications, refer to => Automatic Transmission
37 Removal and Installation.
26 - Bolt
27 - Bracket on Pendulum Support
