A3 L4-2.0L Turbo (BPY) (2006)
/Page-4654010.png)
-
Press in bearing on stop and until a pressing force of 20 kN has been obtained.
-
Remove assembly tool (T10244) from subframe and check seating of the pressed in bonded rubber bushing.
‹› Cutouts of bonded rubber bushings must lie at center in opening of subframe.
‹› The top and bottom of the bonded rubber bushing may project 2 mm above the edges of the subframe in the area of the opening for the pendulum
support.
‹› Gap - arrow - between bonded rubber bushings is permissible.
