A3 L4-2.0L Turbo (BPY) (2006)
Location: Threaded connection longitudinal control arm/wheel bearing housing.
For these operations, it is important to observe the specified sequence!
-
Put longitudinal control arm with bolts - arrows - to wheel bearing housing, but do not tighten at this stage.
-
Insert coupling rod - 1 - in longitudinal control arm, do not tighten nut at this stage.
-
Lift suspension using engine/transmission jack V.A.G 1383 A and wheel hub support T10149 until mounting bracket makes contact with body.
-
Tighten bolts - arrows - onto old impression marks.
-
Lower suspension using engine/transmission jack V.A.G 1383 A and wheel hub support T10149 remove from wheel hub.
-
Install coil spring.
-
Tighten bolts - arrows - for longitudinal control arm to tightening torque, note required position of components while doing so.
-
Tighten coupling rod nut - 1 - to longitudinal control arm.