A3 L4-2.0L Turbo (BPY) (2006)
Tightening of the respective bolts/nuts must then only occur after dimension - a -, which was measured before installation between the wheel hub
center and the lower edge of wheel housing, has been attained
CAUTION.
‹› Do not lift or lower vehicle with engine/transmission jack below vehicle.
‹› Do not leave engine/transmission jack (VAG 1383 A ) below vehicle any longer than necessary.
-
Tighten respective bolts/nuts.
-
Lower wheel bearing housing.
-
Move engine and transmission jack away from under vehicle.
-
Remove wheel hub support (T10149).