A3 L4-2.0L Turbo (BPY) (2006)
‹› Replace
8
Bolt for oil drain bore
‹› Observe different versions
‹› Internal hex bolt - 30 Nm
‹› Internal multi-point bolt - 45 Nm
9
Oil seal
‹› Replace
10
Locking bolt for selector shaft - 30 Nm
11
Bolt - 15 Nm plus an additional 90° (1/ 4 turn)
‹› With permanent washer
‹› Replace
‹› Allocation of bolts as replacement parts, refer to => [ Allocation of bolts as replacement parts ]
12
Bolt - 15 Nm plus an additional 90° (1/ 4 turn)
‹› Without washer
‹› Replace
‹› Allocation of bolts as replacement parts, refer to => [ Allocation of bolts as replacement parts ]
13
Selector Mechanism
‹› Disassembling and assembling, refer to => [ Transmission Side Shift Mechanism Assembly Overview ] See: Shift Linkage/Shift Cable/Service
and Repair/Removal and Replacement/Transmission Side Shift Mechanism Assembly Overview
‹› Removing with transmission installed:
-
Remove battery and battery carrier
-
Remove cables and transmission shift lever
-
Remove locking bolt, remove selector mechanism
14
Bolt, 20 Nm
‹› Replace
15
O-ring
‹› Replace
16
Clutch housing
‹› Servicing, refer to => [ Clutch Housing ] See: Service and Repair/Removal and Replacement/Clutch Housing
17
Transmission housing
‹› Servicing, refer to => [ Transmission Housing ] See: Service and Repair/Overhaul/Transmission Housing
Allocation of bolts as replacement parts