Audi Workshop Service and Repair Manuals > A3 Mk2 > Brake system | ABS, ADR, TCS, EDL, ESP | ABS/ESP system components on rear axle (four-wheel drive vehicles)

Removing and installing speed sensor

Removing

–	Release connector -1- at speed sensor and unplug.

–	Remove bolt -1-.

–	Pull speed sensor -2- out of wheel bearing housing.

Installing

Installation is performed in reverse sequence; note the following:

–	Before inserting speed sensor, clean inner surface of hole and coat speed sensor thoroughly with lubricating paste G 000 650.

Tightening torque

Component		Nm
Speed sensor to stub axle		8

Audi Workshop Service and Repair Manuals