A3 Mk2
Note
|
1 - | Bolt, 10 Nm |
2 - | Brake disc |
q | Allocation, dimensions and wear limit → Chapter |
q | To remove, unbolt brake caliper |
q | Do not force brake discs off wheel hub; if necessary, use rust remover, otherwise brake discs could be damaged. |
q | Always renew on both sides of axle |
3 - | Cross-head bolt, 4 Nm |
4 - | Brake pads |
q | Pad thickness, wear limit → Chapter |
q | Different versions → Parts catalogue |
q | Checking pad thickness → Booklet808 |
q | Removing and installing → Chapter |
q | Note installation position → Fig. |
q | Always renew on both sides of axle |
5 - | Electrical connector |
q | When renewing pads, remove from bracket → Item |
6 - | Brake caliper |
q | Piston diameter → Chapter |
q | Removing and installing → Chapter |
q | Servicing → Chapter |
q | Brake caliper with vibration damper → Chapter |
7 - | Guide pin, 28 Nm |
8 - | Protective cap |
9 - | Brake hose with banjo union and banjo bolt, 35 Nm |
q | Locating pin → Fig. |
10 - | Guide pin, 30 Nm |
11 - | Protective cap |
12 - | Self-tapping screw |
13 - | Bracket |
14 - | Wheel bearing housing |
15 - | Speed sensor |
q | Removing and installing → Chapter |
q | Before inserting sensor, clean inner surface of fitting hole and coat with high-temperature paste -G 052 112 A3- |
16 - | Hexagon socket head bolt |
q | Tightening torque → Item |
17 - | Wheel bearing unit with integrated rotor |
q | Removing and installing → Rep. gr.40 |
18 - | Splash plate |
|
|