Audi Workshop Service and Repair Manuals

Removing and installing brake lines and brake hoses The various brake line fitting locations and torques are given in the following.

Brake lines in area of brake master cylinder/hydraulic unit ITT Mark 60/ ITT Mark 70 1 -  Brake line at brake master cylinder, 14 Nm

Brake lines in area of brake master cylinder/hydraulic unit ITT Mark 60/ ITT Mark 70 1 -  Brake line at hydraulic unit, 14 Nm

Brake lines/hoses in area of front wheel - front-wheel drive vehicles 1 -  Hexagon bolt, 8 Nm 2 -  Brake line, 14 Nm 3 -  Securing clip

Brake hose connection with locating pin –  Make sure groove in banjo union of brake hose is inserted on locating pin -arrow-.

Brake line connection at brake caliper 1 -  Brake line, 14 Nm 3 -  Hexagon bolt, 15 Nm

Brake line connection at underbody 1 -  Brake line, 14 Nm

Brake lines/hoses in area of rear axle - front-wheel drive vehicles 1 -  Brake line, 14 Nm 2 -  Securing clip 3 -  Spacer -3- should face brake caliper when installing.

Brake lines/hoses in area of rear axle - four-wheel drive vehicles 1 -  Brake line, 14 Nm 2 -  Securing clip 4 -  Spacer -4- should face brake caliper when installing.

Brake line connection –  When tightening banjo bolt -2-, counter-hold on banjo nut -1-. t  Tightening torque: 14 Nm