A3 Mk2
| Exploded view |
| 1 - | Bolt, 35 Nm |
| q | Self-locking |
| q | Always renew if removed |
| q | When loosening and tightening, counter-hold on guide pin |
| 2 - | Bleeder screw, 10 Nm |
| q | Before screwing in, grease thread with thin coat of lithium grease -G 052 150 A2- |
| 3 - | Protective cap |
| 4 - | Guide pin |
| q | Lubricate before installing protective cap |
| 5 - | Protective cap |
| q | Insert onto brake carrier and guide pin |
| 6 - | Brake carrier with guide pins and protective caps |
| q | Replacement carriers are supplied assembled and with sufficient grease on guide pins |
| q | If protective caps or guide pins are damaged, renew using repair kit. Use grease sachet supplied to lubricate the guide pins. |
| 7 - | Protective cap |
| q | Push outer sealing lip onto piston |
| 8 - | Piston with automatic adjustment |
| q | Removing and installing → Chapter |
| q | Apply a thin coat of lithium grease -G 052 150 A2- to piston |
| 9 - | Seal |
| q | Do not damage when inserting piston |
| q | Removing and installing → Chapter |
| 10 - | Brake caliper housing with lever for handbrake cable |
| q | Renew the brake caliper housing if there is a leak at the lever for handbrake cable |
| q | After repairing, pre-bleed brake caliper housing → Anchor |
