audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Test step 1 ( glow plug with flame monitor Q8 ) > < Checking components of auxiliary heater
List of electrical checks
   
List of electrical checks
Test stepComponent checkedPage
1Glow plug with flame monitor -Q8-
Earth connection between auxiliary heater control unit -J364- and glow plug with flame monitor -Q8-
→ Chapter
2Overheating fuse -S24- / overheating sensor -G189- and temperature sensor -G18- → Chapter
3Fuel pre-heating heater element -Z66- and fuel shut-off valve -N109-
–  Only fitted on vehicles with auxiliary heater version for diesel fuel
→ Chapter

  Note
t  The installation of a fuel shut-off valve -N109- is currently only planned for vehicles with diesel engine (only installed on VW vehicles; introduction for Audi vehicles not yet finalised) → Electronic parts catalogue
t  Currently no auxiliary heater with a fuel shut-off valve -N109- is installed in Audi A3 vehicles during production (introduction not yet finalised). However it is possible that individual vehicles have been retro-fitted with an auxiliary heater with a fuel shut-off valve -N109-; therefore it is important to pay attention to the correct version.
t  Depending on version of auxiliary heater control unit -J364-, overheating fuse -S24- may also be referred to as overheating sensor -G189-.
   

Test step 1 ( glow plug with flame monitor Q8 ) > < Checking components of auxiliary heater