Audi Workshop Service and Repair Manuals

Removing and installing pipe/hose assembly or plastic pipe Special tools and workshop equipment required

t  Hose clamps, up to 25 mm -3094-

Removing –  Remove complete air cleaner housing → Rep. Gr.24.

Caution When disconnecting the battery there is a risk of serious damage to electronic components: Observe the correct procedure for disconnecting the battery. –  Remove battery → Rep. Gr.27. –  Remove battery tray -arrows- (detach front of battery tray from air duct if applicable).

–  Use hose clamp -3094- to clamp off supply hose to clutch master cylinder.   Note

t  In the following steps make sure that no brake fluid escapes onto the longitudinal member or onto the gearbox below. If this does happen, clean the affected area thoroughly. t  Place a cloth underneath to catch escaping brake fluid. –  Release clip -3- at clutch master cylinder with a screwdriver and disconnect pipe/hose assembly -1- or plastic pipe from connection -4-.

–  Disengage pipe/hose assembly from bracket -C-. –  Release clip -A- at clutch slave cylinder with a screwdriver and disconnect pipe/hose assembly -B- or plastic pipe from connection.   Note -Arrows- can be disregarded. Installing Installation is carried out in reverse sequence; note the following:   Note t  Observe distinction between seals -2- and O-rings → Fig. t  Renew damaged seals or O-rings. –  Connect pipe/hose assembly or plastic pipe to clutch slave cylinder and master cylinder → Fig.. –  Clip pipe/hose assembly into bracket. –  Bleed clutch system → Chapter. –  Install battery tray and battery → Rep. Gr.27. –  Install air cleaner housing → Rep. Gr.24.