audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing oil seal for selector mechanism in gearbox > < Exploded view - selector mechanism in gearbox

A3 Mk2

Removing and installing locking pin
Removing and installing locking pin
Special tools and workshop equipment required
   
t  Tube -T10203-
  W00-1335
Removing
–  Remove air cleaner housing completely → Rep. Gr.24.
  A10-1570
  Caution
When disconnecting the battery there is a risk of serious damage to electronic components:
Observe the correct procedure for disconnecting the battery.
–  Remove battery → Rep. Gr.27.
–  Remove battery tray -arrows- (detach front of battery tray from air duct if applicable).
  A10-1572
–  Remove outer part of locking pin -A-.
–  Carefully lever out locking pin with a screwdriver -arrow-.
  N34-1801
Installing
Installation is carried out in reverse sequence; note the following:
–  Drive locking pin into selector mechanism cover with tube -T10203-.
l  Installation position: Marking -1- should coincide with marking -2- on selector mechanism cover.
–  Install battery tray and battery → Rep. Gr.27.
–  Install air cleaner housing → Rep. Gr.24.
  N34-10199

Renewing oil seal for selector mechanism in gearbox > < Exploded view - selector mechanism in gearbox