A3 Mk2
|
|
Note| The selector fork cluster ( → Item) does not have to be dismantled in order to remove and install detent segments, lock washers and angular contact ball bearings. |
| 1 - | 5th/6th gear detent segment |
| q | Identification → Fig. |
| q | Detent segment should turn freely after lock washer is installed |
| 2 - | Lock washer |
| q | Always renew |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 3 - | 5th/6th gear selector fork |
| 4 - | Bolt |
| q | 25 Nm |
| 5 - | 5th/6th gear selector jaw |
| 6 - | Angular contact ball bearing |
| q | 4x |
| q | Removing → Fig. |
| q | Pressing inner race into outer race → Fig. |
| q | Installing → Fig. |
| 7 - | Selector fork cluster with selector plates |
| q | With selector plate for reverse gear selector mechanism -arrow- |
| 8 - | 1st/2nd gear detent segment |
| q | Identification → Fig. |
| q | The segment must rotate freely after installing the lock washer |
| 9 - | 3rd/4th gear detent segment |
| q | Identification → Fig. |
| q | The segment must rotate freely after installing the lock washer |
