audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox mounting > < Installing gearbox

A3 Mk2

Assembly mountings - exploded view
   
Assembly mountings - exploded view
1 - Bolt
q   40 Nm + 90°
q   Gearbox bracket to gearbox
q   Always renew
2 - Bolts
q   50 Nm + 90°
q   Pendulum support to gearbox
q   Always renew
3 - Engine support
4 - Bolt
q   Engine support to engine
q   Tightening torque → Rep. Gr.10
5 - Engine mounting
6 - Bolt
q   Engine mounting to body
q   Tightening torque → Rep. Gr.10
7 - Connecting bracket
8 - Bolt
q   Connecting bracket to engine mounting
q   Tightening torque → Rep. Gr.10
9 - Bolt
q   Connecting bracket to body
q   Tightening torque → Rep. Gr.10
10 - Bolt
q   Engine mounting to body
q   Tightening torque → Rep. Gr.10
11 - Bolts
q   Engine mounting to engine support
q   Tightening torque → Rep. Gr.10
12 - Pendulum support
q   Removing and installing → Chapter
13 - Bolt
q   100 Nm + 90°
q   Pendulum support to subframe
q   Always renew
14 - Bolt
q   60 Nm + 90°
q   Gearbox mounting to gearbox bracket
q   Always renew
15 - Bolt
q   40 Nm + 90°
q   Gearbox mounting to body
q   Always renew
16 - Gearbox mounting
q   Removing and installing → Chapter
q   Tightening sequence → Fig.
17 - Bolt
q   40 Nm + 90°
q   Gearbox bracket to gearbox
q   Always renew
18 - Bolt
q   40 Nm + 90°
q   Gearbox bracket to gearbox
q   Always renew
19 - Gearbox bracket
q   Removing and installing → Chapter
q   Tightening sequence → Fig.

   
Assembly mounting on gearbox side: tightening sequence
–  First secure gearbox bracket to gearbox -arrows 2-.
–  Pull gearbox up to support arm of gearbox mounting using spindle of support bracket -10 - 222 A-.
–  Screw in bolts -arrows 1- initially hand-tight.
  Caution
The threads in the gearbox bracket can be damaged if the bolts are not inserted straight.
t  Before fitting the bolts -arrow 1-, the gearbox bracket and the support arm of the gearbox mounting must be aligned absolutely parallel. If necessary, push the gearbox up at the rear with a trolley jack.
t  Tighten bolts -arrow 1- only after pendulum support → Item has been installed.
–  Adjust assembly mountings → Rep. Gr.10.
  N34-1828

Removing and installing gearbox mounting > < Installing gearbox