audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - selector mechanism on vehicles from model year 2008 onwards > < Separating gear lever boot from gear knob

A3 Mk2

Exploded view - gear lever and selector housing on vehicles up to model year 2007
Exploded view - gear lever and selector housing on vehicles up to model year 2007
  Note
Lubricate all bearings and moving surfaces with grease -G 000 450 02-.
   
1 - Floor plate
q   Bend tabs open to remove
q   Renew
2 - Gasket
q   Renew if damaged
3 - Gear lever
4 - O-ring
q   Renew if damaged
5 - Retaining clip
q   Renew
6 - Gate selector cable
q   Removing and installing → Chapter
q   Adjusting → Chapter
7 - Gear selector cable
q   Removing and installing → Chapter
q   Adjusting → Chapter
8 - Securing clip
q   Renew
9 - Guide
q   For spring → Item
10 - Bearing shell with damper
11 - Cover
12 - Bush
13 - Securing clip
q   Removing and installing → Fig.
14 - Spring
15 - Bush
16 - Bolt
q   6 Nm
17 - Securing clip
18 - Bearing bush
19 - Gear lever guide
20 - Nut
q   10 Nm
21 - Seal
q   Between selector housing and floor
q   Self-adhesive
22 - Selector housing
23 - Bearing bush
24 - Pivot pin
25 - Guide bush
q   Press onto selector housing
26 - Spring
q   Installing → Fig.
27 - Bolt
q   5 Nm
28 - Gate selector lever

   
Removing and installing securing clip
–  Hold gear lever -2- in position.
–  Press spacer bush -3- in direction indicated -arrow-.
–  Take off securing clip -1-.
  A34-0595
Installing spring
–  Insert arm -A- of spring in guide -1- from above.
–  Pull down arm -B- of spring and insert it in the guide from below.
  Note
Shown in illustration with gate selector lever removed.
  A34-0601

Exploded view - selector mechanism on vehicles from model year 2008 onwards > < Separating gear lever boot from gear knob