Audi Workshop Service and Repair Manuals

Exploded view - gear selector cable and gate selector cable up to model year 2007   Note Lubricate all bearings and moving surfaces with grease -G 000 450 02-.

1 -	Gear selector cable

q	Removing and installing → Chapter

q	Adjusting → Chapter

2 -	Gate selector cable

q	Removing and installing → Chapter

q	Adjusting → Chapter

3 -	Retaining clips

q

Renew

4 -	Selector housing

5 -	Retaining clips

q

Renew

6 -

Bolt

q

20 Nm

q

3x

q	For cable support bracket

7 -	Cable support bracket

8 -

Grommet

9 -	Distance piece

10 -	Cable end-piece

q	Secures gate selector cable to gate relay lever

q	Release to adjust selector mechanism → Chapter

q	Allocation → Fig.

11 -	Cable end-piece

q	Secures gear selector cable to gear lever

q	Release to adjust selector mechanism → Chapter

q	Allocation → Fig.

12 -	Securing clip

q

Renew

13 -	Securing clip

q

Renew

14 -

Bush

15 -	Gate relay lever

q	Installation position → Fig.

16 -	Slide block

17 -

Nut

q	Self-locking

q

Renew

q

23 Nm

18 -	Gearbox selector lever

q	With damper weight

q	Install so that gap in splines aligns with selector shaft → Fig.

q	Installation position → Fig.

Identification of cable end-pieces The holes in the cable end-pieces have different diameters.

Cable end-piece for:	Dimension “a”
1. - Gear selector cable to gearbox selector lever	8.5 mm or 10 mm
2. - Gate selector cable to gate relay lever	8 mm

Cable end-piece for:	Dimension “a”
Gear selector cable to gearbox selector lever	20 mm
Gate selector cable to gate relay lever	18.5 mm

Installing gearbox selector lever –  When installing gearbox selector lever, make sure that the gap in the splines -arrow A- aligns with the wider spline -arrow B- on the selector shaft.

Installation position: gearbox selector lever/gate relay lever 1 -  Gearbox selector lever with damper weight 2 -  Gate relay lever locates in guide rail of gearbox selector lever via slide block -arrow-.

Detaching cable end-pieces from gear selector cable and gate selector cable –  Pull locking mechanism forwards -arrow 1- onto stop and then turn to left -arrow 2- to lock. –  Take cable -B- out of cable end-piece -A-.

Detaching and securing gear selector cable and gate selector cable Detaching –  Lift up tab on securing clip -3- for gear selector cable and detach securing clip from gearbox selector lever -1-. Then pull selector cable off pin. –  Lift up tab on securing clip -4- for gate selector cable and detach securing clip from gate relay lever -2-. Then pull selector cable off pin. Securing   Note t  Renew securing clips. t  Apply a small quantity of grease -G 000 450 02- to the pin. –  Push gear selector cable onto gearbox selector lever -1- and secure with securing clip -3-. –  Push gate selector cable onto gate relay lever -2- and secure with securing clip -4-.