audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pump > < Removing and installing coolant pipes

A3 Mk2

Removing and installing coolant distributor housing with map-controlled engine cooling thermostatF265
Removing and installing coolant distributor housing with map-controlled engine cooling thermostat -F265-
Removing
–  Remove alternator → Electrical system; Rep. gr.27.
–  Remove coolant pipes → Chapter.
   
–  Detach coolant hose -2- from coolant distributor housing; to do so, pull out retaining clip -1-.
  A10-1736
–  Unscrew bolts -arrows- and remove coolant distributor housing with map-controlled engine cooling thermostat -F265- from engine.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torques → Chapter
  Note
t  Renew gaskets and seals.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue.
–  Clean sealing surface for O-ring.
–  Renew O-ring and lubricate with coolant.
–  Install alternator → Electrical system; Rep. gr.27.
–  Fill up with coolant → Chapter.
  N19-10115

Removing and installing coolant pump > < Removing and installing coolant pipes