Audi Workshop Service and Repair Manuals > A3 Mk2 > Power unit | 4-cylinder TDI engine (1.6 ltr. 4-valve common rail), mechanics | Enginecrankshaft group, pistons | Cylinder block (gearbox end)

Removing and installing flywheel

Special tools and workshop equipment required

t	Counterhold tool -3067-

Removing

l	Gearbox or engine removed.

–	Insert counterhold tool -3067- in hole on cylinder block -item B-, slacken bolts for dual-mass flywheel.

Vehicles with dual-mass flywheel:

Caution

Make sure dual-mass flywheel is not damaged.

t	Remove bolts -B- using normal hand tools (do not use pneumatic wrench or impact driver, etc.).

t	When removing the bolts, make sure that the bolt heads do not come into contact with the dual-mass flywheel.

t	Rotate the dual-mass flywheel -A- so that the bolts -B- align centrally with the holes -arrows-.

All vehicles (continued):

–	Remove bolts and take off flywheel.

Installing

Installation is carried out in the reverse order; note the following:

l	Tightening torque → Chapter „Flywheel and sealing flange (gearbox end) - exploded view“

Note

Renew the bolts tightened with specified tightening angle.

–	Insert counterhold -3067- in hole on cylinder block -item A-.

Audi Workshop Service and Repair Manuals