A3 Mk2
| Dual-mass flywheel and sealing flange (gearbox end) - exploded view |
| 1 - | Bolt |
| q | Renew |
| q | 60 Nm + turn 90° further |
| 2 - | Dual-mass flywheel |
| q | Removing and installing → Chapter |
| q | Can only be installed in one position (holes are off-set) |
| 3 - | Sender wheel |
| q | For engine speed sender -G28- |
| q | Removing and installing → Chapter „Renewing sealing flange (gearbox end)“ |
| 4 - | Engine speed sender -G28- |
| q | Removing and installing → Rep. gr.28 |
| 5 - | Bolt |
| q | Tightening torque → Rep. gr.28 |
| 6 - | Dowel pin |
| q | 2x |
| 7 - | Intermediate plate |
| q | Do not damage or bend when assembling |
| q | Installing → Fig. |
| 8 - | Sealing flange (gearbox end) |
| q | With oil seal |
| q | Renewing → Chapter |
| 9 - | Bolt |
| q | Tightening torque and sequence → Fig. |
|
|
|
|
| Stage | Bolts | Tightening torque |
| 1. | -1 … 6- | Screw in bolts by hand until they make contact |
| 2. | -1 … 6- | Tighten in stages and in diagonal sequence; final torque 15 Nm |
