A3 Mk2
Sealing flanges and dual-mass flywheel - exploded view of components |
Note
Servicing clutch → Rep. Gr.30 |
1 - | 15 Nm |
2 - | Oil seal |
q | Renewing → Chapter |
q | Do not lubricate with oil |
3 - | Sealing flange (pulley end) |
q | Must be positioned on dowel sleeves |
q | Removing and installing → Chapter |
4 - | Cylinder block |
5 - | Dual-mass flywheel |
q | Removing and installing → Chapter |
q | Can only be installed in one position (holes are off-set) |
6 - | 60 Nm + 90° (1/4 turn) further |
q | Renew |
7 - | Intermediate plate |
q | Must be positioned on dowel sleeves |
q | Do not damage/bend when assembling |
q | Is fitted on sealing flange → Fig. |
8 - | Sender wheel |
q | For engine speed sender -G28- |
q | Removing and installing → Chapter „Renewing sealing flange (flywheel end)“ |
9 - | 15 Nm |
10 - | Sealing flange (flywheel end) |
q | With oil seal |
q | Renewing → Chapter |
11 - | Engine speed sender -G28- |
12 - | 4.5 Nm |
|