A3 Mk2
| Poly V-belt drive - exploded view |
| 1 - | Poly V-belt |
| q | Check for wear |
| q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
| q | Removing and installing: vehicles with tensioner → Chapter, vehicles without tensioner → Chapter. |
| q | When installing, make sure it is properly seated on pulleys. |
| 2 - | Vibration damper |
| q | With pulley for poly V-belt |
| q | Removing and installing → Chapter |
| 3 - | Special bolt - 10 Nm + 90 |
| q | Renew |
| q | Use only genuine bolts → Electronic parts catalogue |
| 4 - | Poly V-belt tensioner |
| q | Pivot with open-end spanner to slacken poly V-belt |
| q | Lock tensioner with locking pin -T10060 A- or -T10060- |
| q | Not installed on vehicles without air conditioner (equipment version) |
| 5 - | 23 Nm |
| 6 - | Bracket for ancillaries |
| q | Removing and installing → Chapter |
| 7 - | Dowel sleeve |
| q | Ensure correct seating in bracket |
| 8 - | 23 Nm |
| 9 - | Alternator |
| q | Removing and installing → Rep. gr.27 |
| q | To facilitate attachment of alternator, knock back threaded bushes for alternator securing bolts slightly |
| 10 - | 45 Nm |
| q | Apply locking fluid when installing; refer to → Electronic parts catalogue |
| q | Observe correct tightening sequence → Chapter |
| 11 - | Dowel sleeve |
| q | 2x |
| q | Ensure correct seating in bracket |
| 12 - | Air conditioner compressor |
| q | Removing and installing → Rep. gr.87 |
| 13 - | 25 Nm |
