| Removing and installing parts of exhaust system |
Note | t
| Renew gaskets and self-locking nuts. |
| t
| After working on the exhaust system, ensure that the system is not under stress and that it has sufficient clearance from the body. If necessary, loosen clamp and align silencers and exhaust pipe so that sufficient clearance is maintained to the body at all points and the mountings are evenly loaded. |
| t
| The flexible joint in front exhaust pipe must not be bent more than 10° - damage can otherwise occur. |
| t
| Use screwdriver to unfasten and tighten lock washers for heat shields. Tightening torque: 2 Nm |
|
|
|
