Audi Workshop Service and Repair Manuals

Removing and installing cover with oil separator (engine code BYT) Oil separator is fitted in cover only on engine with code letters BYT. Special tools and workshop equipment required

t  Puller -T40039- Removing

–  Pull off top engine cover panel carefully. Do not jerk the cover panel away, and do not try to pull on one side only. –  Carefully disconnect hose -1-.

–  Disconnect vacuum hoses -2-, -3-, -4- and -5-. –  Release electrical connectors -arrows- from ignition coils and unplug all connectors from ignition coils simultaneously.

–  Using puller -T40039-, pull all ignition coils out of spark plug holes. –  Remove cap.

–  Remove 6 bolts -arrows-.

–  Lift up cover towards the right and pull vacuum line out of two clips -arrows-. Installing

–  Pay attention to O-ring -arrow-; renew O-ring if damaged. t  Tightening torque for bolts: 11 Nm –  The remaining installation steps are carried out in the reverse sequence.