A3 Mk2
| Fuel tank with attached components - exploded view |
| 1 - | 26 Nm |
| 2 - | Securing strap |
| q | Installation position: Fixing point (hole) points in direction of travel |
| 3 - | Heat shield for fuel tank |
| 4 - | Breather pipe |
| q | White |
| q | From activated charcoal filter to activated charcoal filter solenoid valve 1 -N80- |
| q | Press release tab on pipe connector to disconnect |
| q | Clip onto fuel tank |
| 5 - | Fuel line |
| q | Black |
| q | To engine |
| q | Press release tab on pipe connector to disconnect |
| 6 - | Breather pipe |
| q | Green |
| q | From fuel system diagnostic pump -V144- to engine |
| q | Press release tab on pipe connector to disconnect |
| q | Clip onto fuel tank |
| 7 - | Electrical connector |
| q | For fuel system pressurisation pump -G6- and fuel gauge sender -G- |
| 8 - | 8 Nm |
| 9 - | Retainer |
| q | Clip onto protective plate |
| 10 - | Protective plate |
| q | For fuel filler neck |
| 11 - | Flange bolt, 11 Nm |
| q | Secures fuel filler neck and earth connection -item 14- |
| 12 - | Filler cap |
| q | Secured to tank flap unit |
| 13 - | Seal |
| q | Renew if damaged |
| 14 - | Earth connection |
| q | To eliminate electrostatic charge |
| q | Installation position → Fig. |
| q | Make sure connector is correctly seated and secure wire with flange bolt for fuel filler neck -item 11-. |
| q | After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body – Specification: approx. 0 Ω |
| 15 - | Breather pipe |
| q | From gravity valve to activated charcoal filter |
| q | Clip onto bracket in wheel housing |
| q | Press release tab on pipe connector to disconnect |
| 16 - | Fuel tank |
| q | Removing and installing → Chapter |
| 17 - | 26 Nm |
| 18 - | Locking washer |
| q | Removing: turn anti-clockwise |
| q | Installing: tighten to 2 Nm |
|
|
Caution