audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Procedure for re-adapting reference position with vehicle diagnostic, testing and information systemVAS 5051B > < Overview of Audi magnetic ride (AMR) - electronic damping control

A3 Mk2

Removing and installing electronically controlled damping control unitJ250
Removing and installing electronically controlled damping control unit -J250-
Removing
The electronically controlled damping control unit -J250- is located under the front right seat.
–  Remove front right seat → Rep. gr.72.
–  Remove sill panel trim (right-side) → Rep. gr.70.
–  Carefully fold back carpet.
   
–  Unclip control unit -1- from mounting bracket -arrows- and take it out.
–  Unplug electrical connector -2- from control unit -1-.
  A40-10318
Installing
Installation is performed in reverse sequence; note the following:
–  Guide rear part of control unit -1- under corners -3- and -4- on mounting bracket and clip in at front -arrows-.
–  Reference position of suspension must be re-adapted if electronically controlled damping control unit -J250- is renewed.
–  Re-adapting reference position → Chapter → Vehicle diagnostic tester.
  A40-10318

Procedure for re-adapting reference position with vehicle diagnostic, testing and information systemVAS 5051B > < Overview of Audi magnetic ride (AMR) - electronic damping control