audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing anti-roll bar - Cabriolet > < Exploded view of anti-roll bar

A3 Mk2

Removing and installing anti-roll bar
Removing and installing anti-roll bar
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Removing
–  Remove rear wheels.
  Note
The following steps are described for the left side of the vehicle. The procedure for the right side of the vehicle is identical.
  W00-0427
–  Unscrew nut -1- and pull coupling rod -2- out of anti-roll bar.
  A42-0425
–  Unscrew bolts -arrows- for anti-roll bar clamp.
–  Remove anti-roll bar.
Installing
Installation is performed in reverse sequence; note the following:
Tightening torques → Chapter „Exploded view of subframe, diagonal strut, lower transverse link, upper transverse link, track rod, vehicle level senders“
Tightening torques → Chapter „Part II: Wheel bearing housing, wheel bearing unit, trailing arm with mounting bracket, stone deflector“
Tightening torques → Chapter „Exploded view of shock absorbers, coil springs“
Tightening torques → Chapter „Exploded view of anti-roll bar“
–  Check and adjust wheel alignment as required, see chart → Anchor.
  A42-0426

Removing and installing anti-roll bar - Cabriolet > < Exploded view of anti-roll bar